Step 4: Connect the power and Ethernet cables
Connect power to your router using one of the following options.
DC power via the six-way connector
Remove the attached green terminal block from your router and connect to the
router's power socket using a DC power supply, sold separately.
DC power via field terminated power source
If an 8-40V DC power supply is available, you can insert the wires into the supplied
terminal block to power your router. Use a flathead screwdriver to tighten the
terminal block screws and secure the power wires, making sure that you have
correctly wired the terminal block as illustrated below.
Terminal
+
-
i
I/O
The green power LED on the router lights up when a power source is connected.
Attach the supplied yellow Ethernet cable 8P8C to the LAN Ethernet port on your
router and the other end to your computer.
12
Description
Positive wire for power.
Ground wire.
Dedicated terminal for ignition detection.
Three terminals used for input/output detection. (Please
refer to the User Guide and SDK Guide for more
information).