NetComm NTC-6200 Series User Manual page 82

Odometer
To access the Odometer screen, select the Services item from the top menu bar then the GPS item on the left. Finally, select the
Odometer menu item.
The GPS may be used to record the distance that the router has travelled. To do this, set the Odometer toggle key to the ON
position as in the screenshot below. You can toggle the unit of measurement by clicking the Display imperial / Display metric button.
The threshold setting adjusts the router's sensitivity to movement so that movement within the specified radius from the starting
point does not register as distance travelled. When you have finished configuring the Odometer settings, click the Save button to
ensure the settings are stored on the router.
ITEM
Odometer reading
Display imperial / Display
metric
Odometer start time
Reset odometer
Odometer
Threshold
NetComm Wireless 3G M2M Router / Plus
82
Figure 96 – Odometer options
The number of metres/kilometres that the device has travelled since the time listed in the Odometer
start time field.
Toggles the Odometer reading between metric and imperial measurements.
The time that recording of distance travelled began.
Resets the odometer reading to 0 and the Odometer start time to the current time.
Toggles the Odometer function on and off.
Specifies the minimum distance that the router must travel from its current position before the
Odometer reading increases.
Table 21 - Odometer configuration options
DESCRIPTION
www.netcommwireless.com