Table of Contents
Advertisement
COMPONENT
256MByte Flash memory storage (~120MB available on board space for user storage)
Memory
Operating System
Embedded Linux 3.6
UMTS bands
UMTS/HSDPA/HSUPA: 800/850/900/1900/2100 MHz
GSM bands
GSM/GPRS/EDGE: 850/900/1800/1900 MHz
HSDPA/HSUPA data rates: DL: 7.2 / 14.4 Mbps, UL: 2.0 / 5.76 Mbps (Concurrent data rate: DL: 7.2 Mbps, UL: 5.76 Mbps)
UMTS data rates: DL: max. 384 kbps, UL: max. 384 kbps
Maximum Data
Throughput / 3G
EDGE class 12: DL: max. 237 kbps, UL: max. 237 kbps
Radio interface
GPRS class 12: DL: max. 85.6 kbps, UL: max. 85.6 kbps
CSD data transmission 14.4 kbps, V.110
1x (RJ-45) 802.3af Power over Ethernet (PoE) 10/100Base-TX
Port with Auto MDIX
1x RS232 Serial Port DB-9 female DCE supporting either 9 wire
RS232 or RS485/RS422 (software selectable)
Connectivity
1 x Mini USB 2.0 OTG interface with 0.5A supply capability
3 x Multipurpose I/O pins
1 x Dedicated ignition input pin
SIM Card Reader
1 x Lockable SIM Card Tray Reader, Push to Release
2x SMA connectors for 2G/3G (1x Main and 1x RX Diversity)
Antenna
connectors
1x SMA connector for GPS
LED Indicators
8x tri-colour LEDs. Power, Network, a GPS/customizable LED and 5x Signal Strength indicators
Embedded GPS receiver (1575.42Mhz)
Active antenna voltage: 3.05V
Maximum current: 50mA
Tracking sensitivity under open sky: -159dBm
Acquisition sensitivity under open sky: -149dBm
GPS
Cold start sensitivity: -145dBm
Time to first fix (TTFF): Cold 25s, Warm 10s, Hot 3s
Short circuit protection
Supports NMEA-0183 (v2.3)
Redirect NMEA stream to serial for forward over IP
Odometer reading available via Web-UI, CLI and SDK
Operating frequency: 2.4GHz, Output power (max): 22dBm,
Zigbee
Internal antennas x 2, Chipset: Silicon Labs EM357
Operating Temperature Range: -20°C ~ +70°C
Operating
Temperature
Storage Temperature Range: -30°C ~ +80°C
Power input and I/O's via 6 way termination block receptacle
Field terminable power input via screw type terminal block
included
DC Power (8 - 40V DC) or via 802.3af Power over Ethernet (PoE)
Vehicle compatible protection on DC Input Jack. (ISO7637
Power input
standard)
Dual power mode supported (PoE primary, seamless failover to
DC Jack on PoE loss)
Recommended power input rating of 6W via DC terminal block
(e.g 12V 1.5A), or Class 3 Power Level via PoE
Dimensions &
143mm (L) x 107mm (D) x 34mm (H) / 221g
Weight
Regulatory
FCC, PTCRB, CE, GCF, WEEE, RoHS, RCM, IC, e-mark
Compliance
NetComm Wireless 3G M2M Router / Plus
146
NTC-6200-11
Table 46 - Technical Specifications of the NTC-6200-11 and NTC-6200-12 Series routers
NTC-6200-12
1x (RJ-45) 10/100Base-TX Port with Auto MDIX
1x RS232 Serial Port DB-9 female DCE supporting either 9 wire
RS232 or RS485/RS422 (software selectable)
1 x Mini USB 2.0 OTG interface with 0.5A supply capability
3 x Multipurpose I/O pins
1 x Dedicated ignition input pin
N/A
Power input and I/O's via 6 way termination block receptacle
Field terminable power input via screw type terminal block
included
DC Power (8 - 40V DC)
Vehicle compatible protection on DC Input Jack. (ISO7637
standard)
Recommended power input rating of 6W via DC terminal block
(e.g 12V 1.5A)
www.netcommwireless.com
Advertisement
Table of Contents
