Ethernet Port Led Indicators - NetComm NTC-6200 Series User Manual

Signal strength LEDs
The following table lists the signal strength range corresponding with the number of lit signal strength LEDs.
LED update interval
The signal strength LEDs update within a few seconds with a rolling average signal strength reading. When selecting a location for
the router or connected or positioning an external antenna, please allow up to 20 seconds for the signal strength LEDs to update
before repositioning.

Ethernet port LED indicators

The Ethernet port of the NTC-6200 Series router has two LED indicators on it.
The table below describes the statuses of each light and their meanings.
LED
Green
Amber
NetComm Wireless 3G M2M Router / Plus
10
NUMBER OF LIT LEDS
All LEDs unlit < -109 dBm
1 -109 dBm to -102dBm
2 -101 dBm to -92 dBm
3 -91 dBm to -86 dBm
4 -85 dBm to -78 dBm
5 ≥ -77 dBm
Table 4 - Signal strength LED descriptions
Figure 3 - Ethernet port LED indicators
STATUS
On There is a valid network link.
Blinking There is activity on the network link.
Off No valid network link detected.
On The Ethernet port is operating at a speed of 100Mbps.
Off The Ethernet port is operating at a speed of 10Mbps or no Ethernet cable is connected.
Table 5 - Ethernet port LED indicators description
SIGNAL STRENGTH
DESCRIPTION
www.netcommwireless.com