Table of Contents
Advertisement
SNMP traps
SNMP traps are messages from the router to the Network Management System sent as UDP packets. They are often used to notify
the management system of any significant events such as whether the link is up or down.
Configuring SNMP traps
To configure SNMP traps:
1.
In the Trap destination field, enter the IP address to which SNMP data is to be sent.
2.
In the Heartbeat interval field, enter the number of seconds between SNMP heartbeats.
3.
Use the Trap persistence field to specify the time in seconds that an SNMP trap persists.
4.
Use the Trap retransmission time to specify the length of time in seconds between SNMP trap retransmissions.
To send a manual SNMP Heartbeat, click the Send heartbeat button. When you have finished configuring the SNMP traps, click the
Save button to save the settings.
Note: When a factory reset is performed via SNMP, the SNMP settings are preserved.
www.netcommwireless.com
Figure 92 - SNMP traps
NetComm Wireless 3G M2M Router / Plus
77
Advertisement
Table of Contents
