NetComm NTC-6200 Series User Manual page 100

get forceplmn get forceplmn
Data connection (PPPoE mode)
get pppoe get pppoe
set pppoe set pppoe=1, telstra.internet, test
LED operation mode
get ledmode get ledmode
set ledmode set ledmode=10
SSH key management
get ssh.proto get ssh.proto
set ssh.proto set ssh.proto=1,2
get ssh.passauth get ssh.passauth
set ssh.passauth set ssh.passauth=1
get.ssh.keyauth get.ssh.keyauth
set.ssh.keyauth set.ssh.keyauth=1
Note: Get/set commands may also be performed on many RDB variables. To obtain a full list of RDB variables, refer to
Appendix H.
NetComm Wireless 3G M2M Router / Plus
100
Returns the operator and network type selection mode (Automatic/Manual), in addition to
the MCC and MNC values
Returns the PPPoE status, currently configured dial string and service name
Sets the PPPoE status on, APN to telstra.internet, and service name to test.
Returns the status of the LED operation mode.
Sets the LED operation mode to be always on or to turn off after the specified number of
minutes.
Returns the SSH protocol in use.
Sets the SSH Protocol to protocol 1, 2 or both (1,2).
Returns the status of the SSH Enable password authentication option.
Sets the SSH Enable password authentication option on or off.
Returns the status of the SSH Enable key authentication option.
Sets the SSH Enable key authentication option on or off.
Table 31 - List of get/set commands
www.netcommwireless.com