NetComm NTC-6200 Series User Manual page 70

UDP client: This creates a UDP client endpoint with the following options available. The retry timeout period specifies the
number of seconds to wait between attempts to re-establish a connection in the event that it is lost. The client will attempt
re-connection indefinitely every Retry timeout interval.
GPS data: This creates a GPS data endpoint.
User defined executable: Allows you to specify an executable and parameters to be used as an endpoint. For example, the
following executable reads the phone module temperature every second.
while true; do wwan.0.radio.temperature; sleep 1; done
The temperature can then be sent to another endpoint.
RS232 / RS485 / RS422 port: These endpoint types all use the built-in serial port. When one of these endpoints is used to
create a stream, the necessary hardware switches to accommodate the chosen serial communication interface are made.
NetComm Wireless 3G M2M Router / Plus
70
Figure 81 - UDP client endpoint configuration
Figure 82 - GPS data endpoint configuration
Figure 83 – User defined executable endpoint configuration
Figure 84 – RS232 / RS485 / RS422 port configuration options
www.netcommwireless.com