Step 1: Power On Your Device; Logging In To The Router - NetComm NWL-15 Quick Start Manual

Logging in to the router

and activating it on the
network
Before you can use your NWL-15 router, a broadband plan must first be added to it.
To add a service to your NWL-15 router, contact your wireless operator (e.g. Verizon
Wireless). You will need to provide the wireless operator with the MEID of your router
to provision a service. The MEID of your router is printed on the box and the label
affixed to the bottom of the router. After the wireless operator has provisioned the
service, you may proceed to activate the NWL-15 router on the network.
The following steps guide you through logging into the web based configuration
interface and activating the router. The web based configuration interface is
also used for status monitoring, advanced configuration and troubleshooting.
To access this interface you'll need a computer with an Ethernet port and web
browser (such as IE, Chrome, Firefox or Safari) installed.

Step 1: Power on your device

Make sure your NWL-15 router is turned on and disconnect any Ethernet connections.
Step 2: Access the router's web interface
Attach one end of the supplied yellow Ethernet cable 8P8C to the LAN Ethernet port
on your router and the other end to your computer. Access the web configuration
interface by entering http://192.168.1.1/ into your web browser. Enter your
username and password and click Log in. See below for the correct login details.
There are two system management accounts (Root Manager and Admin) with different
management capabilities.
NWL-15 - Light Industrial M2M Router Plus
11