Table of Contents
Advertisement
To configure advanced wake settings:
1.
Set Wake mode to Advanced (configure below).
2.
Under Event 1, select whether you want the ignition pin value to be Low or High. If you want to skip this event, select the
Skip option.
3.
In the Event 1 Stable time field, enter the length of time expressed in milliseconds that the value of the ignition line should
remain low or high. For example, to specify 10 seconds, enter a value of 1000.
4.
Under Event 2, select whether you want the ignition pin value to be Low or High. If you want to skip this event, select the
Skip option.
5.
In the Event 2 Stable time field, enter the length of time expressed in milliseconds that the value of the ignition line should
remain low or high.
6.
In the Always wake up after field, enter the time in seconds after which the router should wake up, regardless of whether
Event 1 or 2 has occurred.
When in low power mode and Advanced wake mode is configured, the router waits for Event 1 to occur, then it monitors for Event
2. If Event 2 occurs before Event 1, it will not trigger the condition for either event to have occurred. If Event 1 occurs and then
Events 2 occurs, the router wakes up. Alternatively, if neither or only one of the events occurs, the router waits for the time specified
in the Always wake up after field and then wakes up when that time has been reached.
www.netcommwireless.com
Figure 133 - Advanced wake up configuration
NetComm Wireless 3G M2M Router / Plus
127
Advertisement
Table of Contents
