Removing & Attaching The Remote Control From The Camera Handle; Removing The Remote Control; Attaching The Remote Control - FLIR ThermaCAM P65 HS User Manual

8 – Tutorials
Step
1
2
3
For more information about the battery system, see section 12 – Electrical power
system on page 129.
8.8.7
➲ The remote control is mounted on the camera handle by means of a fixed front
latch and a rear spring-loaded latch. See the figure on page 72.
8.8.7.1
10397203;a3
8
Figure 8.6 Removing the remote control
Step
1
2
3
8.8.7.2
➲ The remote control should not be attached to the camera handle when you use
the heat shield. The heat shield does not protect the remote control from heat.
62
Action
Open the lid of the battery compartment by pressing its locking mechanism.
The battery release spring will push out the battery from the battery compartment.
Close the lid of the battery compartment.
Removing & attaching the remote control from the camera handle

Removing the remote control

Action
Firmly hold the camera in your left hand and grab the handle of the remote control
in your right hand.
Pull the handle backwards until the front of the handle is released from its latch.
You can now remove the remote control from the camera handle.

Attaching the remote control

Publ. No. 1558240 Rev. a156 – ENGLISH (EN) – March 1, 2006