FLIR ThermaCAM P65 HS User Manual page 64

8 – Tutorials
Step
4
5
6
7
8
9
8
54
Action
Select Function by pressing the joystick left/right. This setting defines what mea-
surement function should be used to trigger the alarm.
Select Identity by pressing the joystick left/right to assign an identity to the function
selected above.
Select Output by pressing the joystick left/right until Beep is highlighted.
Specify the Alarm temp by pressing the joystick left/right.
➲ Alarm temp will only be available if Set from ref temp has been disabled below.
Specify whether the alarm temperature should be set from the reference tempera-
ture or not by pressing the joystick left/right.
Specify Delta alarm by pressing the joystick left/right.
➲ Delta alarm will only be available if Set from ref temp has been enabled above.
Publ. No. 1558240 Rev. a156 – ENGLISH (EN) – March 1, 2006