FLIR ThermaCAM P65 HS User Manual page 124

10 – Camera program
Label
Lock scale
10
Lock value
Scale
Status bar
114
Value
Off
■
Max
■
Min
■
Span
■
–
On
■
Off
■
On
■
Off
■
Comments
Move the joystick left/right to lock the temperature
scale to maximum temperature, minimum temper-
atur or a certain temperature span. After having
set Lock scale to Max, Min or Span you will need
to specify a temperature Lock value box.
Typical application for Max:
You are inspecting an object that is located in front
of a background with a considerably higher tem-
perature – e.g. an object in a very hot furnace. In
this case you want to use as many colors as pos-
sible for your object and as few as possible for the
background. To do this, specify a temperature
slightly above the temperature you can expect for
your object.
Typical application for Min:
You are inspecting an object that is located in front
of a background with a considerably lower temper-
ature – e.g. power lines in front of a clear sky. In
this case you want to use as many colors as pos-
sible for your object and as few as possible for the
background. To do this, specify a temperature
slightly below the temperature you can expect for
your object.
Typical application for Span:
You are inspecting an object where you are only
interested in a fixed temperature span – e.g. a fixed
span of, say, 5 degrees for veterinary applications,
or 20 degrees for building applications. In this case
you can lock the span so that a span of 5 and 20
degrees, respectively, is always used and floats
freely around the object temperature.
Move the joystick left/right to specify a temperature
for Lock scale.
Move the joystick left/right to enable or disable the
scale.
Move the joystick left/right to enable or disable the
status bar.
Publ. No. 1558240 Rev. a156 – ENGLISH (EN) – March 1, 2006