Brother DCP-8110DN Service Manual page 106

Error codes C100 to C600
These errors do not usually occur during normal use. The possible causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
---
An unidentified error occurred.
Step
1 Main PCB failure
Error code C700
Out of Memory
Press Stop Key
There is insufficient memory to expand PC-print data.
<User Check>
• Print the print data stored in the memory.
• Expand DIMM.
Error code C800
Out of Memory
Secure Print Data is full. Press Stop Key and delete the previously stored data.
The memory size allotted for Secure Print was exceeded when saving Secure Print data.
<User Check>
• Print the print data stored in the memory.
• Expand DIMM.
Step
1 Main PCB failure
Cause
Replace the main PCB ASSY.
Cause
Replace the main PCB ASSY.
2-61
Remedy
Remedy
Confidential