Brother DCP-8110DN Service Manual page 95

Error code 9500
No Paper
Load #S paper in #T2.
When printing from paper tray 2, the T2 paper feed sensor detected that there was no paper
set in paper tray 2.
<User Check>
• Set the paper in paper tray 2.
Step
Connection failure of the T2
1
paper feed sensor harness
T2 paper feed actuator caught
2
in some sections of the machine
3 T2 paper feed actuator failure
T2 paper feed sensor failure
4
5 T2 relay PCB failure
6 LT connector failure
7 Main PCB failure
Error code 9600
(Non Touch panel model)
No Paper
Load #S paper in #T.
(Touch panel model)
No Paper
Load paper in Tray
When printing with the tray designation set to AUTO, the MP paper empty sensor, T1 paper
feed sensor and T2 paper feed sensor all detected that there was no paper set in the MP
tray, paper tray 1 and paper tray 2.
<User Check>
• Set the paper in any tray.
Step
1 Main PCB failure
Cause
Check the connection of the T2 paper feed
sensor harness, and reconnect it if necessary.
Reattach the T2 paper feed actuator.
Replace the T2 paper feed actuator.
Refer to
(function code: 32)" in Chapter 5
sensor operation. If the sensor operation is
faulty, replace the T2 paper feed sensor PCB
ASSY.
Replace the T2 relay PCB ASSY.
Replace the LT connector
Replace the main PCB ASSY.
Cause
Replace the main PCB ASSY.
2-50
Remedy
"1.3.10 Check sensor operation
Remedy
to check the
Confidential