Download Print this page


Advanced User's Guide
Not all models are available in all countries.
Version 0


   Also See for Brother DCP-8110D

   Related Manuals for Brother DCP-8110D

   Summary of Contents for Brother DCP-8110D

  • Page 1

    Advanced User’s Guide DCP-8110D DCP-8110DN DCP-8155DN Not all models are available in all countries. Version 0 ARL/ASA/NZ/SAF/GLF...

  • Page 2

    This Guide provides useful information PDF file / Installer CD-ROM / Guide about wired network settings and security In the box settings using the Brother machine. You can (for DCP-8110DN and also find supported protocol information for DCP-8155DN) your machine and detailed troubleshooting tips.

  • Page 3: Table Of Contents

    Table of Contents General Setup IMPORTANT NOTE....................1 Memory storage..................... 1 Set Daylight Saving Time ..................1 Ecology features....................2 Toner Save ...................... 2 Sleep Time ...................... 2 Deep Sleep mode .................... 2 Power Down mode (for DCP-8110DN and DCP-8155DN) (Middle East only)..................

  • Page 4

    Routine maintenance Cleaning and checking the machine..............23 Checking the Page Counters.................24 Checking the remaining life of parts ..............24 Replacing periodic maintenance parts..............25 Packing and shipping the machine ..............26 Options Optional paper tray (LT-5400) ................29 Memory board......................29 SO-DIMM Types ....................29 Installing extra memory .................30 Glossary Index...

  • Page 5: General Setup

    Autumn. up to 60 hours. (for DCP-8110DN and DCP-8155DN) Press Menu, 6, 1, 2. (for DCP-8110D) Press Menu, 5, 1, 2. Press a or b to choose On or Off. Press OK. (except Middle East and Africa) Press 1.Change to apply the setting.

  • Page 6: Ecology Features

    Chapter 1 Ecology features Sleep Time The Sleep mode setting can reduce power Toner Save consumption. When the machine is in Sleep mode (Power Save mode) it acts as though it You can save toner using this feature. When is turned off. The machine will wake up and you set Toner Save to On, prints appear start printing when it receives a print job.

  • Page 7: Power Down Mode (for Dcp-8110dn And Dcp-8155dn) (middle East Only)

    General Setup Quiet mode feature Power Down mode (for DCP-8110DN and DCP-8155DN) Quiet mode (Middle East only) The Quiet mode setting can reduce noise while printing. When Quiet Mode is turned On, If the machine is in Deep Sleep mode for 4 the print speed becomes slower.

  • Page 8: Lcd Contrast

    Chapter 1 LCD Contrast Glass ScanSize You can change the contrast to make the When scanning Letter/Legal/Folio size LCD look lighter or darker. documents, you will need to set the scan glass size to Letter or Legal/Folio; Press Menu, 1, 6. otherwise, a portion of your scanned documents will be missing.

  • Page 9: User Settings List

    You can print a list of the machine's settings. (for DCP-8110DN and (DCP-8110DN and DCP-8155DN) DCP-8155DN) Press Menu, 6, 4. (DCP-8110D) Press Menu, 5, 4. The Network Configuration Report is a report listing the current network configuration Press Start. including the network print server settings.

  • Page 10: Security Features

    USB Direct and make changes for each user.  Print  Page Limit Scan includes scan jobs sent via Brother iPrint&Scan. Print includes print jobs via Google Cloud Print and Brother iPrint&Scan. Page Limit is configured using Web Based Management.

  • Page 11: Setting The Password For The Administrator

    Security features Setting the password for the Changing the password for administrator the administrator The password you set in these steps is for the Press Menu, 1, 7, 1. administrator. This password is used to set up users and to turn the Secure Function Press a or b to choose Set Password.

  • Page 12: Setting Up The Public User Mode

    Chapter 2 Setting up the Public user Setting up restricted users mode You can set up users with a password and restrict the functions that are available to Public user mode restricts the functions that them. You can set up more advanced are available for Public users.

  • Page 13: Turning Secure Function Lock On/off

    Security features Turning Secure Function Switching Users Lock on/off This setting allows you to switch between registered restricted users or Public mode If you enter the wrong password, the LCD will when Secure Function Lock is turned on. show Wrong Password. Re-enter the correct password.

  • Page 14: Setting Lock

    Please call your  SCAN when you are in the scan mode. administrator or Brother Customer Service. Then LCD will ask you Go to Public?. While the Setting Lock is On, you cannot change the settings without a password.

  • Page 15: Setting Up The Password

    Setting up the password Changing your Setting Lock password (DCP-8110DN and DCP-8155DN) Press Menu, 1, 7, 2. (DCP-8110DN and DCP-8155DN) (DCP-8110D) Press Menu, 1, 7, 2. Press Menu, 1, 7. (DCP-8110D) Press Menu, 1, 7. Enter a four-digit number for the password using numbers 0-9.

  • Page 16: Turning Setting Lock On/off

    LCD will show Wrong Password. Re-enter the correct password. Turning Setting Lock on (DCP-8110DN and DCP-8155DN) Press Menu, 1, 7, 2. (DCP-8110D) Press Menu, 1, 7. Press a or b to choose On. Press OK. Enter your four-digit password. Press OK.

  • Page 17: Making Copies

    Making copies Copy settings Enlarging or reducing the image copied When you want to quickly change the copy settings for the next copy, use the temporary You can choose the following enlargement or COPY keys. You can change multiple reduction ratios: settings.

  • Page 18

    Chapter 3 Do one of the following:  Press a or b to choose the enlargement or reduction ratio you want. Press OK.  Press a or b to choose Custom(25-400%). Press OK. Use the numeric keys to enter an enlargement or reduction ratio from 25% to 400%.

  • Page 19: Using The Options Key

    Making copies Using the Options key Use the Options key to quickly set the following copy settings temporarily for the next copy. Press Menu selections Options Page Press a or b, then press OK Press a, b, d or c, then press OK Stack/Sort Stack* Sort...

  • Page 20: Sorting Copies

    Chapter 3 Sorting copies Improving copy quality You can sort multiple copies. Pages will be You can choose from a range of quality stacked in the order 1 2 3, 1 2 3, 1 2 3, and so settings. The default setting is Auto. ...

  • Page 21: Adjusting Brightness And Contrast

    Making copies Adjusting Brightness and Contrast Contrast Adjust the contrast to help an image look sharper and more vivid.  To temporarily change the contrast Brightness setting, follow the steps below: Adjust the copy brightness to make copies Load your document. darker or lighter.

  • Page 22: Making N In 1 Copies

    Chapter 3 Making N in 1 copies Put the next page on the scanner glass. Press OK. (page layout) Repeat steps f and g for each page of the document. You can reduce the amount of paper used when copying by using the N in 1 copy After all the pages have been scanned, feature.

  • Page 23: In 1 Id Copy

    Making copies 2 in 1 ID Copy If you are copying from the scanner glass: You can copy both sides of your identification Place your document face down in the card onto one page, keeping the original card direction shown below: size.

  • Page 24: Tray Selection

    30.) machine sets the quality to Photo and the contrast to +2 (-nnnno+). Duplex Copy (long edge flip) Tray selection DCP-8110D and DCP-8110DN  1sidedi2sided L You can change the Tray Use only for the next copy. Portrait Load your document.

  • Page 25

    Making copies DCP-8155DN Enter the number of copies (up to 99) using the numeric keys. Portrait  1 sided i 2 Sided Press Duplex and a or b to select 1sided i 2sided, 2sided i 2sided or 2sided i 1sided. Press OK.

  • Page 26: Advanced Duplex Copy (short Edge Flip)

    Chapter 3 Advanced Duplex Copy DCP-8155DN (short edge flip) Portrait  Advanced 2 sided i 1 sided DCP-8110D and DCP-8110DN  1 sided i 2 Sided S Portrait  Advanced 1 sided i 2sided Landscape Landscape  Advanced 2 sided i 1 sided Load your document.

  • Page 27: A Routine Maintenance

    Routine maintenance Cleaning and checking Important the machine Use neutral detergents. Cleaning with volatile liquids such as thinner or benzine will damage the surface of the machine. Clean the outside and inside of the machine regularly with a dry, lint-free cloth. When you replace the toner cartridge or the drum unit, make sure that you clean the inside of the machine.

  • Page 28: Checking The Page Counters

    (DCP-8110DN and DCP-8155DN) Press Menu, 6, 3. The remaining life of the toner cartridge is (DCP-8110D) listed on the User Settings report. (See Press Menu, 5, 3. User Settings List uu page 5.) Press a or b to see Total, List, Copy or Print.

  • Page 29: Replacing Periodic Maintenance Parts

    50,000 pages for PF Kit MP and 100,000 pages for PF Kit 1, PF Kit 2 , Fuser and Laser. Please call Brother Customer Service when the following messages appear on the LCD. LCD message Description Replace the fuser unit.

  • Page 30: Packing And Shipping The Machine

    15.6 kg. To prevent possible injuries at least two people should lift the machine. Turn off the machine. Leave the (except DCP-8110D and DCP-8110DN) Be machine turned off for at least careful not to pinch your fingers when you 10 minutes to cool down.

  • Page 31

    Routine maintenance Wrap the machine in a plastic bag. Put Put the two packing material pieces (1) the machine on the packing material (1). into the carton matching the right of the machine to the “RIGHT” mark on one of the packing material pieces, and the left of the machine to the “LEFT”...

  • Page 32

    <If you have a Lower Tray> Repack the lower tray as shown in the illustration.

  • Page 33: B Options

    Options Optional paper tray Memory board (LT-5400) DCP-8110D and DCP-8110DN have 64 MB of standard memory, and DCP-8155DN has An optional lower tray can be installed, and it 128 MB. All models have one slot for optional can hold up to 500 sheets of 80 gsm paper.

  • Page 34: Installing Extra Memory

    Installing extra memory Hold the SO-DIMM by the edges and align the notches in the SO-DIMM with the protrusions in the slot. Insert the Turn off the machine’s power switch. SO-DIMM diagonally (1), then tilt it toward the interface board until it clicks Disconnect the interface cable from the into place (2).

  • Page 35

    Options Plug the machine’s power cord back into the electrical socket first, and then connect the interface cable. Turn on the machine’s power switch. Note To make sure that you have installed the SO-DIMM correctly, you can print the User Settings List that shows the current RAM SIZE.

  • Page 36: C Glossary

    Glossary This is a comprehensive list of features and terms that appear in Brother manuals. Availability of these features depends on the model you purchased. ADF (automatic document feeder) Scanning The document can be placed in the ADF The process of sending an electronic...

  • Page 37: Index

    Index Apple Macintosh Machine information See Software User's Guide. checking remaining life of parts .... 24 page counts .......... 24 Macintosh See Software User's Guide. ControlCenter2 (for Macintosh) Maintenance, routine ....... 23 See Software User's Guide. checking the remaining life of parts ..24 ®...

  • Page 38

    Reducing copies ............13 Reports Network Configuration Report ....5 User Settings List ........5 Restricted users .........8 Scanning See Software User's Guide. Security Secure function lock administrator password ......7 Public user mode .........8 restricted users ........8 Setting lock ...........10 Sleep mode ..........2 Sort ............16 Temporary copy settings ......13 Toner Save ..........2...

  • Page 39

    Visit us on the World Wide Web These machines are approved for use in the country of purchase only. Local Brother companies or their dealers will only support machines purchased in their own countries.

This manual also for:

Dcp-8110dn, Dcp-8155dn

Comments to this Manuals

Symbols: 0
Latest comments: