Brother DCP-8110DN Service Manual page 194

(4) Release the ADF motor harness from the guide of the document cover ASSY.
(5) Remove the three taptite cup B M3x10 screws from the lower ADF chute.
(6) Release the hook, and remove the lower ADF chute from the document cover ASSY.
(7) Remove the second side CIS flat cable.
ADF motor harness
Second side
CIS flat cable
Assembling Note:
• The second side CIS flat cable may have been damaged when it was removed from the
FFC holder ASSY. Be sure to replace the second side CIS flat cable with a new one.
Follow the procedure below to attach the new second side CIS flat cable.
<Attachment Procedure>
1) Fold the second side CIS flat cable as shown in the illustration below. (Common to Legal /
A4 models)
Reinforcing tape
Lower ADF chute
Hook
Guide
Fig. 3-54
Mountain fold
Valley fold
Second side CIS flat cable
Fold at edge of reinforcing plate
Fig. 3-55
3-48
Taptite cup B M3x10
20mm
45°
Reinforcing plate
Document cover
ASSY
Confidential