Installing Firmware Using Pc; Setting By Country; Initializing The Eeprom Of The Main Pcb Assy - Brother DCP-8110DN Service Manual

1.1.3 Installing firmware using PC

(1) Press and hold the [5] button and turn ON the power switch of the machine.
"
(2) Connect the computer to the machine with the USB cable.
(3) Turn ON the power switch of the computer.
(4) Open the temporary folder and double-click "FILEDG32.EXE" to start it, and select the
"Brother Maintenance USB Printer."
(5) Drag and drop the panel firmware (LZXXXX_$_upd) in the same folder onto the "Brother
Maintenance USB Printer" icon. The panel firmware file is loaded to the machine, and
installing to the flash ROM starts.
(Start installing from the panel firmware for touch panel models, and from the sub
firmware for other models.)
(6) Vertical stripes flash alternately on the LCD during installation. When installation is
completed, the machine restarts and returns to the ready state automatically.
Do not disconnect the USB cable or turn OFF the power switch of the computer until
installation is completed.
(7) Repeat steps (5) to (6) to install the sub firmware and the main firmware.
Note:
• Install the panel firmware (touch panel models only), sub firmware, and main firmware
in this order.
(8) Turn OFF the power switch of the machine, and disconnect the USB cable.
1.2

Setting by Country

(1) Enter maintenance mode, and press the [7] and [4] buttons in this order. The country
code currently set is displayed on the LCD.
(2) Enter the country code of your country. Refer to
code: 74)" in Chapter 5
(3) Press the [Start] button. The setting is saved, and the machine returns to the initial state
of the maintenance mode.
1.3

Initializing the EEPROM of the Main PCB ASSY

(1) Press the [0] and [1] buttons in this order in the initial state of maintenance mode.
"PARAMETER INIT" is displayed on the LCD. When initializing the EEPROM of the Main
PCB ASSY is completed, the machine returns to the initial state of maintenance mode.
" is displayed on the LCD, and firmware installation mode is entered.
for the country code.
"1.3.23 Setting by country (function
4-3
Confidential