Cartridge Error - Brother DCP-8110DN Service Manual

Error code BE00
This error does not usually occur during normal use. The possible causes are noise around
the installation site, fluctuation of the power supply voltage, and failures in the software.
---
An unidentified error occurred.
Step
1 Main PCB failure
Error code BF00
Scan Unable
Document is too long for duplex scanning. Press Stop key.
The second side document scanning position sensor detected that the ADF was unable to
duplex-feed the document because the document is too long.
<User Check>
• Change the paper size to A4 or letter size.
Step
Second side document
scanning position actuator
1
caught in some sections of the
machine
Second side document
2
scanning position sensor failure
3 Main PCB failure
Error code C000

Cartridge Error

Put the Toner Cartridge back in.
The new toner sensor could not detect the new toner cartridge correctly.
<User Check>
• Set the toner cartridge to the machine correctly.
Step
The power switch was turned
OFF or the front cover was
1
opened while a new toner
cartridge is being detected.
Cause
Replace the main PCB ASSY.
Cause
Reattach the second side document scanning
position actuator.
Replace the second side document scanning
position sensor PCB ASSY.
Replace the main PCB ASSY.
Cause
Reset the developer roller counter. (Refer to
"2.4 Reset Developer Roller Counter" in
Chapter
2-60
Remedy
Remedy
Remedy
5.)
Confidential