Arming In The Latchkey Mode; Initiating A Panic Alarm; Initiating Fire Alarm; Initiating Emergency Alarm - Visonic PowerMax User Manual

SECURING THE PROTECTED SITE

Arming in the Latchkey Mode

(Not to be used in UL-listed systems)
This mode is useful for a parent at work who wants
to be sure that his children have returned from
school and have disarmed the system. Arming in the
"latchkey" mode means that a special "latchkey"
message will be sent out when the system is
disarmed by a "latchkey user".
Latchkey users are holders of user codes 5 through
8 or users of Keyfob transmitters 5 through 8. The
latchkey message is considered an alert and not an
alarm, and is therefore sent to the private telephones
programmed by the user as targets for alert
messages.
Latchkey arming is possible only when you arm "AWAY".
To arm in the Latchkey mode, proceed as follows:
PRESS
(Within 2 seconds)
Vacate the premises
ARM indicator lights during the armed state.

Initiating a Panic Alarm

PRESS
(Pressed
simultaneously)
Note: If you are using a key-ring transmitter, press
both AWAY and HOME buttons simultaneously for 2
seconds.
To stop the alarm, press
valid user code.

Initiating Fire Alarm

(This function is disabled in ACPO compliant version).
PRESS
FIRE
EMERGENCY
10
RESULTANT DISPLAY
ARMING AWAY
ARMING LATCHKEY
(alternating)
PLEASE EXIT NOW
↓ (Exit delay) ↓
AWAY
RESULTANT DISPLAY
PANIC ALARM
Then, if or when the system
is in the disarmed state:
READY HH:MM
and then key in your
RESULTANT DISPLAY
FIRE
Then, if or when
system is in the disarmed
state:
READY HH:MM
To stop the alarm, press
valid user code.

Initiating Emergency Alarm

You can generate an emergency alarm manually
(depends on the purchased system version - see
PowerMax+ door label) in the disarmed and armed
states as follows:
PRESS
EMERGENCY
To stop the alarm, press
your valid user code.

Disarming and Stopping Alarms

(This function is disabled in ACPO compliant version).
Disarming the system stops the siren before it stops
automatically, irrespective of whether the alarm was
initiated in the armed or the disarmed state.
After disarming, different displays may appear,
depending on the current status of the system:
A. Disarming - no events: After an uneventful
armed term,
progress as shown:
PRESS
[Enter code]
ARM indicator extinguishes
B. Disarming after alarm, with all zones ready: If
the zone that alarmed in the armed state is back
to normal, the disarming operation will as shown:
PRESS
code
ARM indicator extinguishes
To read the alarm memory, refer to Chapter 5.
The "MEMORY" message will disappear only
upon re- arming the system.
the
C. Disarming after an alarm, with one zone still
disturbed: If the zone that alarmed in the armed
state is still disturbed, the disarming operation
will progress as shown in the following table.
and then key in your
RESULTANT DISPLAY
EMERGENCY
FIRE
Then, if or when
system is in the disarmed
state:
READY HH:MM
and then key in
the disarming operation
RESULTANT DISPLAY
CODE _ _ _
READY HH:MM
RESULTANT DISPLAY
CODE _ _ _
READY HH:MM
(alternating)
READY MEMORY
the
will
DE5467U