Arming In The Latchkey Mode; Initiating A Panic Alarm; Initiating Fire Alarm; Initiating Emergency Alarm - Visonic POWERMAXPRO User Manual

PRESS RESULTANT DISPLAY
ENTER CODE
ARMING HOME
(To mute the buzzer) HOME
Go to interior zone
ARM indicator flashes during the armed state.

Arming in the Latchkey Mode

This mode is useful for a parent at work who wants
to be sure that his children have returned from
school and have disarmed the system. Arming in the
"latchkey" mode means that a special "latchkey"
message will be sent out when the system is
disarmed by a "latchkey user".
Latchkey users are holders of user codes 5 through
8 or users of Keyfob transmitters 5 through 8. The
latchkey message is considered an alert and not an
alarm, and is therefore sent to the private telephones
programmed by the user as targets for alert
messages.
Latchkey arming is possible only when you arm
"AWAY". To arm in the Latchkey mode, proceed as
follows with the appropriate Keyfob:
PRESS
(Within 2 seconds)
Vacate the premises
Note: Latchkey must be enabled by your installer.
ARM indicator lights during the armed state.

Initiating a Panic Alarm

You can generate a panic alarm manually in the
disarmed and armed states alike. The sequence will
be as shown:
PRESS
Note: If you are using a key-ring transmitter, press
both AWAY and HOME buttons (MCT-234) or AUX1
and AUX2 (MCT-237) simultaneously for 2 seconds.
D-302542
_ _ _ _
↓ (Exit delay) ↓
HH:MM
RESULTANT DISPLAY
ARMING AWAY
ARMING LATCHKEY
(alternating)
PLEASE EXIT NOW
↓ (Exit delay) ↓
AWAY
RESULTANT DISPLAY
PANIC ALARM
READY HH:MM
SECURING THE PROTECTED SITE
To stop the alarm, press
valid user code.

Initiating Fire Alarm

(This function is disabled in ACPO compliant version).
You can generate a fire alarm in disarmed & armed
states, as follows:
PRESS
To stop the alarm, press
valid user code.

Initiating Emergency Alarm

You can generate an emergency alarm manually in
the disarmed and armed states, as follows:
PRESS

Disarming and Stopping Alarms

(This function is disabled in ACPO compliant version).
Disarming the system stops the siren before it stops
automatically, irrespective of whether the alarm was
initiated in the armed or the disarmed state.
After disarming, different displays may appear,
depending on the current status of the system:
A. Disarming - no events: After an uneventful
armed term the disarming operation will progress
as shown:
PRESS
ARM indicator extinguishes
and then key in your
RESULTANT DISPLAY
FIRE
Then, if or when the system
is in the disarmed state:
READY HH:MM
(alternating)
READY MEMORY
and then key in your
RESULTANT DISPLAY
EMERGENCY
Then, if or when the system
is in the disarmed state:
READY HH:MM
(alternating)
READY MEMORY
RESULTANT DISPLAY
CODE _ _ _ _
READY HH:MM
11