Arming In The Latchkey Mode; Initiating A Panic Alarm; Initiating Fire Alarm; Initiating Emergency Alarm - Visonic POWERMAXCOMPLETE User Manual

Arming in the Latchkey Mode

This mode is useful for a parent at work who wants
to be sure that his children have returned from
school and have disarmed the system. Arming in the
"latchkey" mode means that a special "latchkey"
message will be sent out when the system is
disarmed by a "latchkey user".
Latchkey users are holders of user codes 5 through
8 or users of Keyfob transmitters 5 through 8. The
latchkey message is considered an alert and not an
alarm, and is therefore sent to the private telephones
programmed by the user as targets for alert
messages.
Latchkey arming is possible only when you arm "AWAY".
To arm in the Latchkey mode, proceed as follows:
PRESS
(Within 2 seconds)
Vacate the premises
ARM indicator lights during the armed state.

Initiating a Panic Alarm

You can generate a panic alarm manually in the
disarmed and armed states alike. If this feature has
been enabled by
installation company to determine if it has been
enabled).The sequence will be as shown:
PRESS
(Pressed
simultaneously)
Note: If you are using a key-ring transmitter, press
both AWAY and HOME buttons simultaneously for 2
seconds.
To stop the alarm, press
valid user code.

Initiating Fire Alarm

(This function is disabled in ACPO compliant version).
You can generate a fire alarm manually (depends on
the purchased PowerMaxComplete version - see
PowerMaxComplete door label) in disarmed & armed
states, as follows:
D-302755
RESULTANT DISPLAY
ARMING AWAY
ARMING LATCHKEY
(alternating)
PLEASE EXIT NOW
↓ (Exit delay) ↓
AWAY
the installer (consult
RESULTANT DISPLAY
PANIC ALARM
Then, if or when the system
is in the disarmed state:
READY HH:MM
and then key in your
SECURING THE PROTECTED SITE
PRESS
To stop the alarm, press
valid user code.

Initiating Emergency Alarm

You can generate an emergency alarm manually
(depends on the purchased system version - see
PowerMaxComplete door label) in the disarmed and
armed states as follows:
PRESS
To stop the alarm, press
valid user code.

Disarming and Stopping Alarms

(This function is disabled in ACPO compliant version).
Disarming the system stops the siren before it stops
automatically, irrespective of whether the alarm was
initiated in the armed or the disarmed state.
After disarming, different displays may appear,
depending on the current status of the system:
your
A. Disarming - no events: After an uneventful
armed
progress as shown:
PRESS
[Enter code]
ARM indicator extinguishes
B. Disarming after alarm, with all zones ready: If
the zone that alarmed in the armed state is back
to normal, the disarming operation will as shown:
PRESS
ARM indicator extinguishes.
RESULTANT DISPLAY
FIRE
Then, if or when the system
is in the disarmed state:
READY
and then key in your
RESULTANT DISPLAY
EMERGENCY
Then, if
system is in the disarmed
state:
READY
and then key in your
term, the disarming
RESULTANT DISPLAY
CODE
READY
RESULTANT DISPLAY
CODE _ _ _
code READY
(alternating)
READY MEMORY
HH:MM
or when the
HH:MM
operation will
_ _ _
HH:MM
HH:MM
11