Arming Away 'Instant; Arming Home 'Instant; Forced Arming Away; Forced Arming Home - Visonic PowerMaxExpress User Manual

ARM indicator flashes during the armed state.
If an alarm occurred while the system was armed in
the AWAY mode, the display will respond differently:
PRESS
[Enter code]
Move to interior zone
ARM indicator flashes during the armed state.

Arming AWAY 'Instant'

You may arm AWAY or HOME without an entry
delay - any detection in any zone will trigger an
immediate alarm.
If you wish to arm AWAY-INSTANT, proceed as
follows.
PRESS
Vacate the premises
ARM indicator lights during the armed state.

Arming HOME 'Instant'

If you wish to arm HOME-INSTANT, proceed as follows:
PRESS
Move to interior zone
ARM indicator flashes during the armed state.
D-303974 PowerMaxExpress User's Guide
RESULTANT DISPLAY
ENTER CODE _ _ _ _
ARMING HOME
 (Exit delay) 
HOME HH:MM
(alternating)
ARM HOME MEMORY
RESULTANT DISPLAY
ENTER CODE _ _ _ _
ARMING AWAY
ARMING INSTANT
(alternating)
PLEASE EXIT NOW
 (Exit delay) 
AWAY
RESULTANT DISPLAY
ENTER CODE _ _ _ _
ARMING HOME
ARMING HOME
(alternating)
ARM HOME INSTANT
 (Exit delay) 
HOME HH:MM
SECURING THE PROTECTED SITE

Forced Arming AWAY

Forced arming allows you to arm the system /
partition even though one zone or several zones are
disturbed, and the NOT READY message is
displayed.
Automatic forced arming only works if the installer
allowed this option while programming your system.
Disturbed zones will be bypassed - they will not be
armed. The protected site will not have maximum
protection.
Note: When forced arming is carried out, the buzzer
"protests" by emitting a continuous tone during the exit
delay until the last 10 seconds of the delay. You can
silence this signal by pressing the arming button again.
When NOT READY is displayed, Forced arming
"AWAY" is performed as follows:
PRESS
(to mute the buzzer)
ARM indicator lights during the armed state.

Forced Arming HOME

When NOT READY is displayed, Forced arming
"HOME" is performed as follows:
PRESS
(To mute the buzzer)
Go to interior zone
ARM indicator flashes during the armed state.

Arming in the Latchkey Mode

This mode is useful for a parent at work who wants
to be sure that his children have returned from
school and have disarmed the system. Arming in the
"latchkey" mode means that a special "latchkey"
message will be sent out when the system is
disarmed by a "latchkey user".
Latchkey users are holders of user codes 5 through 8 or
users of Keyfob transmitters 5 through 8. The latchkey
message is considered an alert and not an alarm, and
is therefore sent to the private telephones programmed
by the user as targets for alert messages.
RESULTANT DISPLAY
ENTER CODE _ _ _ _
ARMING AWAY
PLEASE EXIT NOW

(Exit delay)
AWAY
RESULTANT DISPLAY
ENTER CODE _ _ _ _
ARMING HOME
 (Exit delay) 
HOME HH:MM

9