List Of Alarms And Other Indications - JRC JMA-5206 Instruction Manual

List of Alarms and other Indications

Message
SET GYRO
TM RESET
POSN RESET
Message
CPA/TCPA
GUARD ZONE
LOST
RADAR ALARM(IN)
RADAR ALARM(OUT) A target doesn't exist in a radar alarm zone.
Table 8-7 List of Operational Error Messages and Warnings
Message
NO HEADING DATA
NO POSITION DATA
OUT OF RANGE
CHANGE RANGE
MAX POINT
CAN'T TRANSMIT
INVALID DATA
MAX TARGET
SELECT STRAIGHT
NO CARD
CARD FULL
FORMAT CARD
INVALID CARD
READ FAILED
WRITE FAILED
DELETE FAILED
FORMAT FAILED
COPY FAILED
NOT ALLOWED
Table 8-5 List of Notification
Requires setting of true bearing.
Use care of resetting TM.
Change the latitude and longitude sentence.
Table 8-6 List of ATA Alarms and Radar Alarms
Closest approach point/Time for reaching the closest approach point (ATA)
A target exists in a guard zone.
A target under acquisition cannot be tracked.
A target exists in a radar alarm zone.
ATA operation or TM selection when bearing data is invalid
Mark or line input when the latitude and longitude is invalid.
ATA out of acquisition range
TM selection due to TM-disabled range (96 or 120 nm)
Zooming in a ZOOM-disabled range (0.125 nm)
Tried to enter navigation information beyond the specified.
Tried to transmit within 1 second after standby or when the transmitter-
receiver has any trouble.
Tried to enter any data beyond its range.
The maximum number of targets of ATA is under acquisition.
The operator set PM to ON without selecting straight.
Card not detected yet
Card capacity insufficient
Unformatted card
Invalid card
Read failure
Write failure
Deletion failure
Format failure
Copy failure
General operation error
Description
Description
Description
8─19