JRC JMA-5206 Instruction Manual page 348

[IV] Reception Port Setting (RX Port)
Set the number of the port via which signals are received from sensors.
Procedures 1
2
3
4
5
* For AUTO, the initial value will be selected.
Select the number of the port to be used, pressing the numeric key.
Exit 1
Open the Equipment Setup Menu.
Press [5] key.
The COM Port Setting Menu will appear.
Press [4] key.
The RX Port Menu will appear.
Select the signal you want to set,
pressing the numeric keys [1] to [6].
The Reception Port Setting Menu for each
signal will appear.
Settable signals
1. GPS
2. DLOG
3. Depth
4. Temperature
5. Wind
6. Current
Select which port you want to use for
output.
Types of ports to be used
1. AUTO
2. COM1 (GPS)
3. COM2 (PC)
4. COM3 (NAV1)
5. COM4 (NAV2)
Press [RADAR MENU] key.
The Main Menu will reappear.
8─47
RX Port
1. GPS
AUTO
1. AUTO
2. DLOG
2. COM1 (GPS)
AUTO
3. COM2 (PC)
3. Depth
4. COM3 (NAV1)
5. COM4 (NAV2)
4. Temperature
AUTO
5. Wind
AUTO
6. Current
AUTO
7. Rate of Turn
8. Rudder
0. EXIT
OFF
AUTO
AUTO