JRC JMA-5206 Instruction Manual page 62

Turns on/off the radar interference rejector function (IR). The selection changes in the following
sequence each time the button is clicked.
IR OFF → IR LOW → IR MED → IR HIGH
→See section 3.4.8 on page 3-20.
⑪: Selection of radar video enhance function (ENH)
Turns on/off the radar video enhance function. The selection changes in the following sequence
each time the button is clicked:
ENH OFF → ENH LEVEL1 → ENH LEVEL2 → ENH LEVEL3
→See section 3.5.11 on page 3-47.
⑫: Selection of radar video processing function (PROC)
Selects a video processing mode. The selection changes in the following sequence each time
the button is clicked:
PROC OFF → 3SCAN CORR → 4SCAN CORR → 5SCAN CORR →
REMAIN → PEAK HOLD
→See section 3.5.12 on page 3-48.
⑬: Selection of processing setting function (FUNC)
Selects a processing setting mode. The selection changes in the following sequence each time
the button is clicked:
FUNC OFF → FUNC1 → FUNC2 → FUNC3
The currently selected function mode name is shown on the button.
→See section 3.11 on page 3-124.
⑭: Selection of MANUAL/AUTO for sea clutter suppression function (SEA)
Selects whether to use the sea clutter suppression function in manual or automatic mode. The
bar shown at left indicates the control setting position.
→See section 3.4.6 on page 3-17.
⑮: Selection of MANUAL/AUTO for rain/snow clutter suppression function (RAIN)
Selects whether to use the rain/snow clutter suppression function in manual or automatic mode.
The bar shown at left indicates the control setting position.
→See section 3.4.7 on page 3-19.
⑯: Selection of radar trail display function (TRAILS)
Sets up the trail time of the radar to be displayed. The setting of trail time can be changed.
→See section 3.5.9 on page 3-44.
→For the selection of trail time length, see section 3.10.2 on page 3-85.
⑰: Selection of radar trail mode
Selects the true-motion trail mode or relative-motion trail mode in which the radar trail function
is to operate.
T is displayed when the true-motion trail mode is selected;
relative-motion trail mode is selected.
This selection is limited by the radar video motion mode.
While relative motion (RM) is indicated, the true-motion trail mode or relative-motion trail mode
can be selected.
While true motion (TM) is indicated, only the true-motion trail mode can be selected.
→See section 3.5.9 on page 3-45.
2─9
→ FUNC4
R is displayed when the