JRC JMA-5206 Instruction Manual page 65

→See section 3.5.3 on page 3-26.
: Numeric data display mode of EBL2
40
Selects the numeric data display mode of EBL2 depending on the true or relative bearing. The
selection changes each time the button is pressed.
T is displayed while true bearing is selected;
selected.
→See section 3.5.3 on page 3-26.
: Memory intervals for own ship track display
41
Selects track data memory intervals for own ship. The setting changes each time the button is
pressed.
→See section 3.6.2 on page 3-68/70.
42 : Selection of units of memory intervals for own ship's track display
Selects units of memory intervals for own ship's track display. The selection switches back and
forth between
sec → min and nm each time the button is clicked.
→See section 3.6.2 on page 3-68.
: Selection of bearing sensor
43
The bearing sensor in use is displayed.
: Selection of speed sensor
44
Selects a speed sensor. The selection changes in the following sequence each time the button is
pressed.
MAN → LOG
(Manual) (1-axis log) (2-axis log water)
An alarm occurs if a speed sensor not connected to the radar is selected.
While MAN is selected for the speed sensor, a value can be entered by moving the cursor to
the value area and left-clicking.
: Selection of time display mode
45
Selects UTC or LOCAL for the time display mode. The selection changes each time the
button is pressed.
UTC: Universal time coordinated
LOCAL: Local time
→See section 8.6 on page 8-96.
2.2 FUNCTIONS OF SOFTWARE BUTTONS
→ 2AXW →
2AXG
(2-axis ground)
2─12
R is displayed while relative bearing is
→ GPS
2