JRC JMA-5206 Instruction Manual page 114

Trails modes provided with this system vary depending on the motion mode.
With true motion (TM) mode:
With relative motion (RM) mode: The relative motion trails mode or true motion trails mode is
While the true motion trails mode is active, this system enables the continuous use of true motion
trails even if any of the following operations is performed:
• Motion display mode change [TM/RM] key
• TM reset [TM/RM] key
• Bearing display mode change [AZI MODE] key
• Center move [OFF CENT] key
• MAP display on/off [MAP] key
* Button
Note: Accurate true bearing signals and speed signals are necessary for using the true motion trails
mode.
Changing Motion Mode of Trails (Trails mode)
Procedures 1
2
→ For other settings, see section 3.10.2, page 3-100
17 on the radar display on page 2-7 is also available to change trial motion mode.
Press [RADAR MENU] key twice.
Press [2] key.
The RADAR Trails Setting Menu will appear.
Press [2] key.
The setting of radar trails display mode will be
switched between TRUE and
RELATIVE.
TRUE : True motion trails
RELATIVE : Relative motion trails
Only the true motion trails mode is available.
selectable.
RM(R) is indicated while the relative motion trails mode is
active.
RM(T) is indicated while the true motion trails mode is
active.
3─45
RADAR Trails Setting
1. Trails Interval
6 min
2. Trails Mode
TRUE
3. Trails REF Level
LEVEL2
4. Trails Reduction
5. Time/Cont Combine
6. Trails Process
7. Max Interval
SHORT
9. NEXT
0. EXIT
OFF
OFF
OFF
>