Bosch ICP-EZM2 Easy Series System Reference Manual page 99

Easy Series
Exiting Test Mode
To exit the Test Mode locally:
1.
2.
3.
When the detector exits Test Mode, the green Event LED (Item 6, Figure 10.9 on Page 95)
stops flashing. If the Event LED continues to flash, repeat Steps 2 and 3.
To exit the Test Mode remotely:
1.
2.
3.
Entering RFSS Mode with the Wall Tamper Removed
To enter RFSS Mode if the wall tamper tab is removed:
1.
2.
Figure 10.12 Wall and Cover Tamper Switches
1
2
3.
Low Battery Indication
The detector indicates a low battery condition in two ways:
–
–
The LED flashing and a low battery indication at the control panel are independent of each
other and do not necessarily occur at the same time. Receiving either condition indicates a
low battery.
Bosch Security Systems, Inc.
Carefully open the service door of the detector.
Insert a screwdriver into the slot next to the sensitivity switches that contains the test
pads (Item 1, Figure 10.9 on Page 95).
Momentarily short both test pads together with the tip of the screwdriver, or other
metallic conductive object.
Stand within 3 m of the detector.
Move the switches on top of the 13-332 Tester to ACTIVATE and to MAN modes (Items 1
and 3, Figure 10.9 on Page 95).
Point the front of the tester towards the detector and press the red Start button on top
(Item 2, Figure 10.9 on Page 95).
The tester buzzes.
Remove and reinsert the batteries.
Press and hold the wall tamper switch.
Refer to Figure 10.12 on Page 99.
Wall tamper switch (back of detector)
Cover tamper switch (inside of detector)
Quickly press and release the cover tamper switch four times within 10 sec of reinserting
the batteries. Refer to Figure 10.12 on Page 99. The detector enters RFSS Mode.
If the LEDs are enabled, both flash simultaneously every sec.
A low battery status indication is sent to the control panel.
System Reference Guide
Device Specifications and Overview | en
F01U087835 | 02 | 2008.10
99