Wlsn Hub - Bosch ICP-EZM2 Easy Series System Reference Manual

Easy Series
10.7

wLSN Hub

Specifications
868 MHz
915 MHz
Wire Gauge
Wire Length
Power/Voltage
Current Draw
Compliance
The wLSN Hub monitors and coordinates two-way communications between the control panel
and the detectors.
Rotary switches (S1, S2, and S3) configure device operation and enable special diagnostic
modes.
An LED on the front provides device status.
General Operation
Refer to Table 10.5 on Page 81 and Table 10.6 on Page 81 for an overview on wLSN Hub LEDs
and switch settings.
Operation
Self Test and Hardware Failure
Standard Operation
Configuring Network
RFSS Mode
Table 10.5 wLSN Hub LED Displays
Function
Normal Operation
RFSS Mode
Default Mode
Table 10.6 wLSN Hub Switch Settings
Bosch Security Systems, Inc.
ISW-BHB1-WX
ISW-BHB1-WY
0.14 mm to 1.5 mm
100 m
12 VDC nominal, 7 to 14 VDC
60 mA maximum
EN50131-1 Security Grade 2 Type C, Environmental Class II
LED Display
LED flashes twice per sec. This indicates failure. The wLSN Hub does
not operate.
LED on.
LED flashes once every 2 sec.
LED flashes once every 4 sec.
S1
1
9
9
System Reference Guide
Device Specifications and Overview | en
Switches
S2
0
2
8
F01U087835 | 02 | 2008.10
81
S3
0
0
7