Assigning Points 1 To 8 As Wireless Points; Recovering The Wireless Network; Wireless System Messages - Bosch ICP-EZM2 Easy Series System Reference Manual

32 en | Point Expansion
Button Menu Option
Press
[6] Erase and Discover
[#] Exit Wireless
Configuration
Table 3.2 Wireless Configuration Menu Options
3.3.2

Assigning Points 1 to 8 as Wireless Points

To assign an on-board point (1 to 8) as a wireless point, disable the point in programming
before starting the device discovery process. You can individually assign Points 1 to 8 as
wireless points.
3.3.3

Recovering the Wireless Network

Expert Programming Item Number 9999 restores the control panel to its factory default
settings. All wireless network data in the control panel is lost, but is retained in the wireless
hub.
To recover wireless network data from the wireless hub:
1.
2.
3.3.4

Wireless System Messages

Refer to the following table for a description of system messages that pertain to the wireless
network.
System Message
"Wireless devices not configured."
"Extra device ignored."
"Point x was tested."
"Point x low."
"Please wait."
"Wireless error."
"Wireless devices x."
"Wireless devices not tested x."
"Point x not tested."
Table 3.3 Wireless System Messages
F01U087835 | 02 | 2008.10
Description
If the wireless data in the control panel does not match the wireless data in the
hub (Bus Device Trouble 50), use this option to erase the wireless data in both
the control panel and hub, and rediscover all devices.
This option is only available if the wireless data does not match in the control
panel and hub.
Select this option to return to the System Maintenance options.
From the Installer Menu of a phone session (refer to Section 2.7.2 Initiate a Phone Session
from the Control Panel, Page 22), press [1] to select System Maintenance.
Press [6][5] to transfer wireless data from the hub to the control panel.
This option deletes key fob assignments. You must reassign all key fobs.
Description
Point Test was exited before all wireless points were tested.
An attempt was made to add a device to a system that already contains the
maximum number of points or outputs.
A point was tested. RFSS is acceptable.
A point was tested. RFSS is unacceptable.
The wireless network is busy, or the control panel is waiting for the wireless
network to respond. The control center might show a single rotating segment
of the circle of protection with this message.
The wireless hub is jammed, missing, or experiencing a trouble condition.
"x" = the number of devices that are discovered, but not tested.
"x" = the number of devices that are discovered, but not yet configured.
The control panel assigned a point number to the device, but the device was
not tested (faulted, or tampered, and restored).
"x" = the voice description.
By default, the system announces the point number.
System Reference Guide
Easy Series
Bosch Security Systems, Inc.