Discover A New System; Establish And Configure The Wireless Network - Bosch ICP-EZM2 Easy Series System Reference Manual

Easy Series
3.2.1

Discover a New System

Discovery is the process through which the wireless hub identifies and includes new
(undiscovered) devices into the system.
NOTICE!
i
You can only perform the new system discovery process once. To update an existing wireless
system, refer to Section 3.3 Wireless Maintenance, Page 31.
There are two ways to start the discovery process on a new system: point test, and the
Wireless Configuration Menu: Point Test and the Wireless Configuration Menu.
Point Test
The device discovery process automatically starts at the beginning of the Point Test.
To start a point test from the System Test Button:
1.
2.
To start a point test from the Phone Menu:
From the Installer Menu of a phone session (refer to Section 2.7.2 Initiate a Phone Session from
the Control Panel, Page 22):
–
OR
–
Wireless Configuration Menu
1.
2.
3.2.2

Establish and Configure the Wireless Network

The wLSN Hub automatically establishes and configures the wireless network.
The wLSN Hub evaluates each available radio frequency (RF) for noise, RF signal strength, and
other adjacent wireless systems. The wLSN Hub then selects the frequency with the lowest
amount of noise and least amount of traffic for network operation.
To configure the wireless network, the wLSN Hub selects the best channel for broadcasting.
Once a channel is selected, the wLSN Hub then configures all discovered devices to operate
on the selected frequency. This process takes several minutes.
Bosch Security Systems, Inc.
Ensure that all devices have exited RFSS Mode, including the wLSN Hub.
Ensure the wLSN Hub is in normal operating mode (LED is on steady).
Press the System Test button for one second.
Press [1], and then press [2] to select Full System Test.
Press [1], and then press [3] to select System Test Menu. From the System Test Menu,
press [5] to select Point Test.
Enter the Installer Menu of a phone session (refer to Section 2.7.2 Initiate a Phone Session
from the Control Panel, Page 22).
Press [1][6] to select System Maintenance Wireless Configuration. The device discovery
process automatically starts.
System Reference Guide
Point Expansion | en 29
F01U087835 | 02 | 2008.10