Bosch ICP-EZM2 Easy Series System Reference Manual page 26

26 en | System Installation and Configuration
6.
State/Comments
1
No control panel authorization received.
2
Installer is authorized for Configuration
mode, or authorization is not required.
3
Received invalid SMS.
4
Received valid SMS authorizing
configuration.
→
Key: = Scrolling LEDs, from left to right.
Shifting flash = Every other LED flashes simultaneously, creating the shifting flash pattern.
Table 2.9 Configuration Mode (J200 Jumper Installed) LED States
NOTICE!
If the LEDs indicate an invalid SMS, remove the configuration jumper and then repeat the
i
steps in Section 2.8.2 Configure the ITS-DX4020-G, page 25.
If the LEDs continue to indicate an invalid SMS, the SMS template might be incorrect. Confirm
the SMS template format and settings and try again, or use a USB connection to configure the
ITS-DX4020-G.
7.
8.
CELL IP Status
Off ITS-DX4020-G is not connected to the GPRS network.
Flash ITS-DX4020-G is connected to the GPRS network, but not connected to the Bosch receiver.
On ITS-DX4020-G is connected to the Bosch receiver through the GPRS network.
Table 2.10 D6600 Connection Status
F01U087835 | 02 | 2008.10
Observe the LEDs to confirm that the communicator received a valid configuration SMS.
Valid SMS configurationsshould be received within 5 min. Refer to row 4 in Table 2.9,
Page 26.
LED State
STATUS
→
→
→
→
⊗
= LED's status does not matter.
Remove the configuration jumper. The communicator reboots.
Ensure that the ITS-DX4020-G can communicate with the D6600/DX6600i. Refer to
Table 2.10, Page 26.
System Reference Guide
CELL IP AUDIO SS1
→ →
GSM Signal Strength
→ →
GSM Signal Strength
→ →
Flash
→ → →
Easy Series
SS2 SS3
Flash Flash
→ →
Bosch Security Systems, Inc.
BUS
Off
On
Flash
→