Accessing The User Interface And Logging On Using Usb; Downloading The Its-Dx4020-G Usb Driver; Installing The Its-Dx4020-G Usb Driver - Bosch ICP-EZM2 Easy Series System Reference Manual

Easy Series
9.3

Accessing the User Interface and Logging On Using USB

9.3.1

Downloading the ITS-DX4020-G USB Driver

Before you can access the USB user interface, you must download and install the ITS-DX4020-
G.inf file on the target PC or laptop. You only need to install this file once on the target PC or
laptop.
1.
2.
3.
4.
5.
6.
Figure 9.2 File Download Window
7.
9.3.2

Installing the ITS-DX4020-G USB Driver

If the target PC or laptop only has one USB port, you only need to install the USB driver once.
If the target PC or laptop has multiple USB ports, you must install the USB driver each time
the ITS-DX4020-G is connected to a new USB port.
1.
2.
Figure 9.3 Found New Hardware Wizard
Bosch Security Systems, Inc.
From your Internet browser, go to http://www.boschsecurity.us/en-us/ to open the US
Bosch web site.
Under Online Catalogs, click Intrusion Alarm Systems.
Under Download Library, click Software.
Under Software, click Intrusion Alarm Systems.
Under Intrusion Alarm Systems, click Conettix - Information Transport Solutions.
To the right of ITS-DX4020-G.INF, click EN.
The File Download window opens.
Click Save to save the file to the target PC or laptop.
Ensure that the supplied jumper plug is covering the CONFIG jumpers.
Refer to Figure 9.1, Page 62, Callout 3.
Supply power to the ITS-DX4020-G (12 VDC) and connect it to the target PC or laptop,
using a USB-to-mini-USB (5-pin mini-B connector) cable (not supplied).
The Found New Hardware Wizard opens.
System Reference Guide
ITS-DX4020-G Communicator Configuration | en
F01U087835 | 02 | 2008.10
65