Configure Devices - Bosch ICP-EZM2 Easy Series System Reference Manual

30 en | Point Expansion
3.2.3

Configure Devices

Input and Output Devices
NOTICE!
i
The ISW-BMC1-S135X Door/Window Contact and the ISW-BIN1-S135X Inertia Detector have a
magnetic switch as an input. If the magnetic switch is not used, remove the magnet from the
device before starting the Point Test.
Once the network is established and configured, the system announces "Test all points." Test
the wireless devices in this order: input devices, output devices, and relay modules.
NOTICE!
Do not exit the Point Test until all intended wireless devices are tested. Otherwise, you must
manually add devices to the system.
i
If extra wireless devices not intended for installation are within the wireless hub's range, the
wLSN Hub might also discover these devices. To exclude any unused devices from the system,
press [#] (or [5] from the control center) to exit the Point Test. The wLSN Hub returns all
unused devices to the undiscovered state.
When you restore the device, the system announces the assigned device number.
Test Devices
Point numbers are assigned to wireless devices in the order that the devices first
communicate to the system (tampered, faulted, low battery). If specific point numbers are
preferred for wireless devices, ensure that the wireless devices communicate in the
appropriate order. Otherwise, the system assigns the lowest available point number to the
first tested wireless device. With motion detectors, unmask only the detector you want to
test. Refer to Table 2.6 on Page 24 for wLSN device testing instructions.
Key Fobs
1.
2.
3.
4.
5.
6.
To create a key fob-only system (no wireless input or output devices installed), start at Step 2.
In a key fob-only system, adding the first key fob might take several minutes to complete as
the wireless network is established and configured. Subsequent key fob additions take less
time.
F01U087835 | 02 | 2008.10
After the last wireless device is configured and the Point Test ends, press [#] repeatedly
until you exit the Installer Menu and end the phone session.
Start a new phone session, or press and hold [3] on the control center, and enter the
master user (User 1) passcode.
Press [4] [1].
Enter a passcode, and then re-enter the passcode.
Press [4] to add a key fob. Token assignment and voice description are optional.
Repeat Steps 4 to 7 to add more users and key fobs, or press [#] repeatedly to end the
phone session.
System Reference Guide
Easy Series
Bosch Security Systems, Inc.