Programming Access Options; System Access By Phone - Bosch ICP-EZM2 Easy Series System Reference Manual

Easy Series
4

Programming Access Options

You can access the system to make programming changes using:
–
–
–
4.1

System Access by Phone

NOTICE!
i
Once you configure a control panel using the Phone Menus, you can copy the programming
from the control panel to a programming key for use on another control panel, or for backup.
Refer to Section 4.3 Programming Keys, page 36.
The Installer Phone Menu and User Phone Menu provide access to system functions such as
testing the system, programming the system, and adding or changing users.
The Installer Phone Menu requires the installer passcode.
The User Phone Menu requires either the master user (User 1) passcode for full menu access,
or a user passcode for limited menu access.
If the passcode length = four digits:
–
–
If the passcode length = six digits:
–
–
To access the system menus, select one of the options shown in Table 4.1, Page 33.
Options Steps
House Phone –
–
–
Outside Phones –
–
–
–
Installer Quick Select this option if a phone line is not available, or a local connection is required. The
Connect system must be off to use this option.
–
–
–
–
Table 4.1 Phone System Access Options
Bosch Security Systems, Inc.
The Phone Menu
Remote Programming Software (RPS)
A Programming Key (using programming copied from a control panel previously
programmed using the Phone Menu or RPS)
The default installer passcode is 5432
The default master user passcode is 1234
The default installer passcode is 543211
The default master user passcode is 123455
Press [#][#][#].
Listen for the voice prompt to enter a passcode.
Enter the installer passcode to access the installer menu, or a user passcode to access
the user menu.
Call the premises phone number.
After the call is answered by a person or by a telephone answering device, press
[*][*][*] to disconnect the answering party and access the system.
Listen for the voice prompt to enter a passcode.
If the phone is not answered by a person or telephone answering device, the system
answers after a programmed number of rings. Refer to Expert Programming Item
Number 222 listed in on Section Route Destination Items, page 47.
Enter the installer passcode to access the installer menu, or a user passcode to access
the user menu.
Connect a phone set to the test posts or to the phone terminals.
Press and hold the System Test button for approximately 15 sec.
Listen for the voice prompt to enter a passcode.
Enter the installer passcode to access the Installer Menu, or a user passcode to access
the User Menu.
System Reference Guide
Programming Access Options | en
F01U087835 | 02 | 2008.10
33