Prepare The Wlsn Hub For Site Testing And Rfss Mode; Wlsn Installation Tool Mode 1 - Bosch ICP-EZM2 Easy Series System Reference Manual

Easy Series
2.5.1

Prepare the wLSN Hub for Site Testing and RFSS Mode

1.
2.
3.
Switch 3 Setting
0
1
2
3
4
Table 2.3 wLSN Hub RF Power/EN Settings
Refer to individual device's specification for their EN50131 classification.
NOTICE!
i
You must test the devices at the same EN50131 Security Grade at which the control panel
discovers the devices.
4.
5.
2.5.2

wLSN Installation Tool Mode 1

Mode 1 identifies if a device location has acceptable or unacceptable RFSS.
To test the wireless devices with the Installation Tool in Mode 1:
1.
2.
3.
4.
5.
–
M
–
M
If the location tests:
–
–
Bosch Security Systems, Inc.
Unlock the wLSN Hub and separate it from its base.
Set Switch S1 to 9 and Switch S2 to 2 to enable RFSS mode. This disables normal
operation. Refer to Figure 1.1, Page 6.
Set Switch S3 to a value of 0 to 4, based upon the RF power level or EN50131 security
grade you wish to use. Refer to Table 2.3.
RF Power (EN50131 Security Grade
Maximum power
3 dB lower than maximum (Security Grade 1)
6 dB lower than maximum (Security Grade 2)
9 dB lower than maximum (Security Grade 3)
12 dB lower than maximum (Security Grade 4)
Find a suitable location for the hub base and apply power by either connecting it to the
control panel (refer to the control panel's installation instructions), or temporarily
connecting a 9 VDC to 12 VDC battery.
Reconnect the wLSN Hub and base, and then lock the wLSN Hub.
Verify that the wLSN Hub rotary switch is set to S1 = 9, S2 = 2, S3 = 0. Refer to Figure 1.1,
Page 6. The wLSN Hub's LED flashes slowly.
Go to the first device location, and then press and hold [*][#] on the Installation Tool for
2 sec.
Press [1] for Mode 1.
Place the Installation Tool in an upright position at the first device location, or hold it in
the location, if necessary.
Wait 10 sec and then review the display.
Acceptable RFSS Display:
O D E
Unacceptable RFSS Display:
O D E
OK: Confirm that the location is OK by testing it with the actual wireless device for this
location.
Not OK: Test a different location.
System Reference Guide
System Installation and Configuration | en
1 : + +
1 : - N
+ O K + +
O T O K
F01U087835 | 02 | 2008.10
19
+
-