Bosch ICP-EZM2 Easy Series System Reference Manual page 88

88 en | Device Specifications and Overview
LED/Button
Programmable buttons
High intensity LED
button
Table 10.7 wLSN Key Fob LEDs and Buttons
Status
Alternating red and green
Red fast flash
Red slow flash
Red on steady
Green fast flash
Green slow flash
Green on steady
Green on steady and slow
amber flash
Red on steady and slow
amber flash
Red blip
Table 10.8 wLSN Key Fob LED Status
F01U087835 | 02 | 2008.10
Function
To operate the programmable buttons, press and hold
Program these buttons at the control panel to control lights, garage doors, and so on.
Refer to Expert Programming Items 616 and 626 on page 56.
Press [FIG] to operate the high intensity LED.
Description
A key fob button was pressed. The LED either stops flashing, or one of the other status
indicators in this table occurs. This display lasts approximately for 15 sec.
The system is in alarm, or silent panic feature was used.
Exit delay in progress (system occupied or unoccupied).
The system is on (occupied or unoccupied).
An error occurs while turning the system on. The system does not turn on as expected.
The system is not ready to turn on. A button programmed for system status also shows
this status.
The system is off and is ready to turn on. The button programmed for system status
also shows this status.
Either or was pressed to turn an output on or off.
Either or was pressed to turn an output on for two seconds.
If the LED flashes red once every 5 sec when the key fob is not in use, replace the
batteries.
System Reference Guide
Easy Series
or for at least one sec.
Bosch Security Systems, Inc.