Delete Plu - Sam4s NR-500 Series Operating And Programming Manual

Delete PLU

Note: Before a PLU can be deleted, all report information must be cleared. It may
be necessary to run a Z1 and Z2 PLU Report, and if the PLU is an inventory item,
you must change the stock to zero.
If PLUs had been registered by using the NOT FOUND PLU function, RESET N.F
PLU must be issued. See page on 71 for details.
Delete One PLU
Delete PLU Range
SAM4S NR-500 Series Manual
1. From the PLU PROGRAMMING screen, press 2 and CASH to display the
DELETE PLU screen:
DE LE TE
1. ON E P LU
2. RA NGE P LU
2. Press 1 and CASH to delete an individual PLU. The PLU NUMBER screen
displays:
D EL ET E
EN TER P LU #
3. Enter the number of the PLU you wish to delete and press CASH. The
DELETE message will print.
1. From the PLU PROGRAMMING screen, press 2 and CASH for to display
the DELETE PLU screen:
DE LE TE
1. ON E P LU
2. RA NGE P LU
2. Press 2 and CASH to delete a range of PLUs. The PLU NUMBER screen
displays: Enter the number of FROM PLU# in the range you wish to delete.
Press CASH.
DE LE TE
EN TER F RO M PL U#
0
0
Program Mode Programming • 123