Flash Rom Updates - Sam4s NR-500 Series Operating And Programming Manual

Flash ROM Updates

The NR-500 Series register software is loaded in flash ROM. This program may
occasionally be updated by the manufacturer. Your SAM4S dealer can update the
software if necessary. The Flash ROM can be loaded through a PC or by SD card.
CAUTION: Flash ROM update by either method must be done by a qualified,
trained technician. DO NOT POWER OFF OR ABORT any program loading once
it has started. Failure to follow the procedures exactly may cause the program to
load incompletely and for the register to fail completely.
Flash ROM Update by SD
The NR-500 Series Flash ROM program is contained in a binary file. This file contains
both the Boot program area and the Application program area.
Boot Area Update
Program Area Update
SAM4S NR-500 Series Manual
1. Copy binary file to the update folder of the SD card. : SD:/update
2. Insert the SD card into the register. (The SD slot is located inside the printer
compartment. Remove the security screw and open the flap securing the SD
slot. Insert the SD card until you hear a click sound and the SD card is locked
in.)
3. At the NR-500 Series, move to the SERVICE MODE.
4. Press the ↑ ↑ ↑ ↑ key and the
confirm. Select the 7.PROGRAM BACKUP menu. Then select "1.SD".
5. Select the 6.BOOT UP SD menu.
6. After a short pause, the register will display confirmation of the successful
download with the message "DOWNLOAD 100 % FINISHED!.
7. Turn the ECR power switch OFF/ON and proceed directly to the next step:
Application Update.
8. Set the SERVICE MODE.
9. Press the upper right key and the lower right key. A rapid beep-beep-beep
sound will be heard. Release the upper right key and the lower right key.
↑ ↑ ↑ ↑
10. Press the key and the
confirm. Select the 2.SD menu.
11. The display will flash (Current program is being erased), after a few seconds,
the display will continue to flash, but at a slower rate. This continues for about
1-minute while the new program is being loaded. When the load is complete, a
rapid beep-beep-beep sound will be heard again the display will stop flashing
and display a blue color to confirm update completion.
12. Power the register OFF. The FLASH ROM update is complete.
13. Remove the SD card from the register.
14. Perform a memory all clear on the ECR. The ECR is now ready to program or
to load a previously saved end-user program.
↓ ↓ ↓ ↓ key to select menu and press the CASH key to
↓ ↓ ↓ ↓
key to select menu and press the CASH key to
Service Mode Programming • 105