Clearing Memory - Sam4s NR-500 Series Operating And Programming Manual

Clearing Memory

Before you use your NR-500 Series ECR for the first time, you must perform a memory all
clear to insure that all totals and counters are cleared and that the default program is
installed.
CAUTION: The procedures described in this area are security sensitive. Clearing
the NR-500 Series memory after the register is put into service will erase all
programming as well as totals and counters. Do not share this information with
unauthorized users and distribute the "SERVICE MODE" only to those you may
want to perform these functions.
1. Move to the SERVICE MODE.
2. Turn the power switch located on the right side of the register to the OFF position.
3. Press and hold the key position where the CHEQUE key is located on the default
4. Continue to hold the appropriate key while turning the power switch to the ON
5. Press the upper left key of the keyboard, then the lower left key, then the upper
1
2
1
2
SAM4S NR-500 Series Manual
keyboard layout.
position. The message "RAM ALL CLEAR" displays.
right key, and finally press the lower right key.
<NR-500R Series>
PRICE
PRICE
<NR-500 Series>
3
CHEQUE
( )
↓ ↓ ↓ ↓
4
3
CHEQUE
( )
↓ ↓ ↓ ↓
4
.
Getting Started • 25