Delete Plu - Sam4s ER-230EJ Operating And Programming Manual

Delete PLU

Note: Before a PLU can be deleted, all report information must be cleared. It may be
necessary to run a Z1 and Z2 PLU Report, and if the PLU is an inventory item, you
must change the stock to zero.
If PLUs had been registered by using the NOT FOUND PLU function, RESET N.F
PLU must be issued. See page on 59 for details.
Delete One PLU
Delete PLU Range
SAM4S ER-230EJ Manual
1. From the PLU PROGRAMMING screen, press 2 and CASH to display the
DELETE PLU screen:
DELETE
1. ONE PLU
2. RANGE PLU
2. Press 1 and CASH to delete an individual PLU. The PLU NUMBER screen
displays:
ENTER PLU #
3. Enter the number of the PLU you wish to delete and press CASH. The
DELETE message will print.
1. From the PLU PROGRAMMING screen, press 2 and CASH for to display
the DELETE PLU screen:
DELETE
1. ONE PLU
2. RANGE PLU
2. Press 2 and CASH to delete a range of PLUs. The PLU NUMBER screen
displays: Enter the number of FROM PLU# in the range you wish to delete.
Press CASH.
ENTER FROM PLU#
3. Enter the number of TO PLU# in the range you wish to delete.
ENTER TO PLU #
4. Press CASH to delete the PLU. The DELETE message will print.
5. Continue to delete another PLUS or press CLEAR key until return to
PROGRAM MODE menu.
0
0
20
Program Mode • 111