Check - Sam4s NR-500 Series Operating And Programming Manual

CHECK #

CHECK # Key Program Notes
Option
DESC
KEY DISABLE
COMPULSORY
FOR ALL SALES
OPENING
CLERK HAS
EXCLUSIVE
ACCESS
PRINT ON
RECEIPT
PRINT ON
REMOTE
ALLOW ONLY
ONE CHK PER
TABLE
CHECK #
ASSIGNED BY
REGISTER
DRIVE THRU
FEATURE
ENABLED
LENGTH OF
CHECK (0-9)
SCAN CHECK #
136 • Program Mode Programming
Entry Description
Alpha You can program a unique descriptor. The default
numeric descriptor is CHKTRACK.
24 character
Y or N
Select Y to disable this function.
Y or N
Select Y you must begin a new, or recall an existing
tracking number before registering items.
Y or N If Y, the clerk that begins a tracking number is the only
clerk who can recall a check. If N, any clerk can recall
any check.
Y or N
If N, the check track number and balance will not print on
the receipt.
Y or N
If N, the check track number and balance will not print on
the remote.
Y or N If Y, you can begin only one check with the same table #.
Y or N If Y, press the CHECK. # key to automatically assign
the next sequential check. Check numbers will begin with
#1 and continue until the open check report is reset, at
which point the check number will be reset and start from
#1 again.
Y or N If you wish to implement a drive thru recall key, this
setting changes the function of the PBAL key to that of a
recall key. Press the PBAL key directly to automatically
recall the open check with the lowest tracking number
Y or N Set the length of check in number of digits. For example,
if 4, then checks must be used in the range from 1000, to
9999. This setting applies to only check numbers input
by the operator, not to check numbers assigned by the
register.
Y or N Choose Y to allow the check number to be inputted by a
scanner (must be nine digits or less).
SAM4S NR-500 Series Manual