Testing The Control Panel And Remote Control - Response SL3 Installation And Operating Manual

2. Press the
Control or
Press
?
Keypad User Access Code
on the Remote Keypad.
If the Remote Control/Keypad is new and not already
linked the panel will produce a two short beeps and
the next available zone LED will start flashing, (once
every second).
Note: If the Remote Control/keypad is already
linked to the control panel or if there are already
the maximum 6 Remote Controls/Keypads linked
to the control panel then the panel will produce a
single long beep and the signal from the new
Remote Control will be ignored.
3. Confirm the device ID code by pressing the
button on the same new Remote Control within
15 seconds or
using the Keypad, confirm by pressing
? ? ?
Keypad User Access Code
The panel will produce three short beeps and
the zone LED will stop flashing and remain ON.
Note: If the confirmation signal is not
received within 15s the LED will stop
flashing and turn off. The panel will exit to
the top level of Learn Mode without saving
any changes. The learning process will
need to started again to link the new device.
The ID code of the new Remote Control/Keypad
is now stored in memory ready for saving.
4. Press to save new settings and return to
ENTER
step1 or press
ESC
5. If after adding a remote, no more remotes
require linking then press
Mode.
button on the new Remote
,
? ? ?
,
?
1
to exit without saving.
to exit Learn
ESC
To delete all linked Remote Controls/Keypads
from the Control Panel:
1. Place the Control Unit into Learn Mode. With
the system in Standby
,
Press
? ?
User Access Code
The Arm and Part-Arm LEDs will illuminate and all
Zone, Fire and Tamper LEDs will flash together.
1 0
2. Press
3. Press
All illuminated zone LEDs indicating linked
devices will start flashing, (once every second).
4. Press again within 15 seconds to confirm
ENTER
and erase the device links.
The flashing zone LEDs will extinguish.
Note: If the erase is not confirmed within
15s the LEDs will stop flashing and remain
illuminated. All links will remain intact and
will not be erased.
5. Press ENTER to save new settings and return to
step1 or press
ESC
6. If after deleting a remote, no more remotes
require deleting then press
Mode.
TESTING THE CONTROL PANEL AND
REMOTE CONTROL
1. Arm the Control Panel by pressing the
button on the Remote Control.
The Zone LED will illuminate for a few seconds
to indicate which zones are being armed. As the
entry/exit delay expires the Control Panel will
slowly beep and the Arm LED will flash. Towards
the end of the delay the beep rate will increase.
When the entry/exit delay is completed the
beeping will stop and the Arm LED will stop
flashing and be constantly illuminated.
2. Disarm the system by pressing the button on the
Remote Control.
The Control Panel will beep twice and the Arm
LED will turn OFF .
,
? ?
ENTER
on the Control Panel.
to exit without saving.
to exit Learn
ESC
11