Table of Contents
Advertisement
Remote Keypad
Included in S 2 E system, available as
an optional accessory for the S 1 E,
S 1 E PLUS and S 1PF E systems.
Transmit
Low Battery
Indicator
Indicator
LED
LED
0
1
2
3
4
5
6
7
8
9
The Wireless Remote keypad is used to control the
system by using a four digit User ccess Code.
The Remote keypad incorporates Panic and anti-
tamper protection features that will immediately
initiate a Full
larm condition when activated.
attempt to open the casing of the Remote keypad
will immediately initiate a Full larm condition even if
the system is disarmed, (unless the system is in
Service mode). In addition if a sequence of more
than 16 incorrect key presses is entered the Remote
keypad will be disabled for the next 1 minute. During
this 1 minute duration the
slowly. Consecutively disabled for 3 times, the Remote
Keypad will emit the tamper signal to the Siren.
The Remote Keypad is powered by a 9V PP3 lkaline
battery. Under normal operating conditions this will
provide an expected life in excess of 1 year. When
the battery level falls below an acceptable level, the
"LOW B TTERY" indicator on the front of the Remote
Keypad will flash.
When this occurs the battery
should be replaced as soon as possible.
Positioning the Remote Keypad
The Remote Keypad is rated IP44 and suitable for
mounting outdoors. The Remote Keypad should be
mounted in a position close to the main entrance door
so that the user access code can be entered easily.
Ensure that the position selected for the Remote
Keypad is within the effective range of the Siren.
Key Pressed
Confirmation
Indicator LED
Arm
Disarm
1
Delay-Arm 1
1
2
Delay-Arm 2
2
LED will keep flashing
Note: DO NOT fix the Remote Keypad to metalwork
or locate the unit within 1m of metalwork (i.e.
radiators, water pipes, etc) as this could affect the
radio range of the Remote Keypad.
Installing and Configuring
the Remote Keypad
Ensure that the Siren is in Service mode.
Wall Mounting Plate
ny
1. Undo and remove the fixing screw from the
bottom edge of the Remote Keypad and remove
the wall mounting plate
2. Using the mounting plate as a template, mark the
positions of the four fixing holes on the wall.
Note: To make the best use of anti-tamper
protection you must insert a wall plug and screw
in the specified hole (as illustrated).
3. Fix the mounting plate to the wall using the
screws and wall plugs provided, (a 5mm hole will
be required for the wall plugs).
tighten the fixing screws as this may distort or
damage the mounting plate.
Note: Installing the Remote Keypad against a flat
and smooth wall is of great importance so as to
avoid the tamper switch being falsely triggered.
Note: The wall plugs supplied with the product
are not suitable for plasterboard walls, if
mounting the Remote Keypad on to plasterboard
use appropriate wall plugs.
4. Undo and remove the two fixing screws in the rear
of the Remote Keypad and remove the rear cover.
7
Anti-Tamper
Protection
Fixing
Screw
Do not over-
Hide quick links:
Advertisement
Table of Contents
