Larm Duration; Part- Rm; Zone Lockout - Response SA3 E PLUS Installation And Operating Instructions Manual

Press the key corresponding to the required delay
setting required, the corresponding zone LED will
illuminate as the setting is changed.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
ESC
saving.

larm Duration

Default setting: 3 minutes
5
Press
The zone LED corresponding to the current setting
will illuminate.
0 no alarm
1 1 minute
2 2 minutes
3 3 minutes
4 5 minutes
5 10 minutes
Press the key corresponding to the required alarm
period, the corresponding zone LED will illuminate as
the setting is changed.
Note: When set to 'No alarm' the Siren will sound for
approx. 10 seconds if an alarm condition is initiated.
Press to save the new setting and return to
programming mode.
Press to return to programming mode without
ESC
saving.
Note: Following initiation of a Full
the External Siren will continue to sound until either
the system is Disarmed; or the Control Panel
Duration Time expires; or if activated until the 3
minute alarm time limit of the external Siren expires;
whichever occurs first.

Part- rm

Default setting: Zone 1
Press
The zone LEDs corresponding to the zones currently
active during Part- rm mode will be illuminated. LEDs
for zones disabled during P RT- RM will be OFF.
To change the setting of a zone press the button
corresponding to the zone number. The zone will toggle
between the two modes each time the button is pressed.
Press
programming mode.
Press
saving.

Zone Lockout

This feature, if enabled, prevents a single zone from
triggering an alarm condition more than three times
before the system is disarmed. However, if disabled
there is no limit on the number of times a zone can
trigger an alarm condition.
Default setting: ON
Press
The zone 1 LED will illuminate to indicate the current
Zone Lockout status.
larm condition
Press
state.
larm
Press
programming mode.
Press
saving.
20
Zones 2-6
6
LED ON Zone enabled in Part- rm
LED OFF Zone disabled in Part- rm
to save the new setting and return to
to return to programming mode without
ESC
7
LED ON Zone Lockout enabled
LED OFF Zone Lockout disabled
1
to change the setting to the opposite
to save the new setting and return to
to return to programming mode without
ESC
Disabled
ctive