Instant/Delay Zones; Entry/Exit Warning Tone; Part-Arm; Zone Lockout - Response SL3 Installation And Operating Manual

Press to save the new setting and exit to
ENTER
Program Mode, or
Press to exit without saving.
ESC

INSTANT/DELAY ZONES

This defines which zones will operate in conjunction
with the systems entry/exit delay period and which
zones will instantly trigger an alarm when activated
while the system is armed. Delay zones will not
become active (armed) until the exit-delay has
expired and when triggered will only initiate an
alarm after the entry-delay has expired.
Default setting: zone 1: Delay, zones 2 - 6: Instant
3
Press
The zone LEDs corresponding to the zones
currently set to Delay will be illuminated. LEDs
for zones set to Instant will be OFF .
LED ON
LED OFF
To change the setting:
Press the button corresponding to the zone
number to be changed. The zone's status
(delay or instant) will switch to the opposite
state each time the button is pressed.
Press to save the new setting and exit to
ENTER
Program Mode, or
Press to exit without saving.
ESC

ENTRY/EXIT WARNING TONE

This allows the warning beeps which are generated
during the entry/exit delay to be switched ON or OFF
as required.
Default setting: ON (enabled)
4
Press
The zone 1 LED will illuminate to indicate the
current status of the Entry/Exit warning tone.
LED ON
LED OFF
Delay Zone
Instant Zone
Tone enabled
Tone disabled
To change the setting:
Press 1
The warning tone status will switch to the
opposite state each time the button is pressed.
Press to save the new setting and exit to
ENTER
Program Mode, or
Press to exit without saving.
ESC

PART-ARM

This controls which zones are operational when the
Part-Arm feature is activated.
Default setting: zones 1 - 4: Enabled
zones 5 - 6: Disabled
5
Press
The zone LEDs corresponding to the zones
currently active during Part-Arm mode will be
illuminated. LEDs for zones disabled during
Part-Arm will be OFF .
LED ON
LED OFF
To change the setting:
Press the button corresponding to the zone
number to be changed. The zones status will
switch to the opposite state (enabled/disabled)
each time the button is pressed.
Press to save the new setting and exit to
ENTER
Program Mode, or
Press to exit without saving.
ESC

ZONE LOCKOUT

This feature if enabled, will only allow a single zone
to trigger an alarm up to 3 times before the system
is disarmed. However, if this feature is disabled
there is no limit on the number of times a zone can
trigger an alarm condition.
Default setting: ON (enabled)
6
Press
Zone enabled in Part-Arm
Zone disabled in Part-Arm
27