Table of Contents
Advertisement
3. Turn ON your TV and VCR or DVR.
4. Playback a tape on the VCR or recorded video on the DVR to confirm your TV is on
the correct channel.
5. Tune the input viewing channel of the VCR or DVR until your camera appears on
screen. If you are unable to tune the VCR or DVR, consult the VCR / DVR instruction
manual or contact its manufacturer *.
* To tune the TV or VCR / DVR to view the camera, press the button associated with,
Source, Line In, L1, L2, AUX, A / V, channel 0 etc. Consult the TV or VCR / DVR instruction
manual for details about changing the input channel on the device.
Note: By
default the camera and receiver will be set to channel 1. If poor reception is
received by any camera set to a specific channel and adjusting the orientation of the
receiver's antenna doesn't help, then set the camera to another unused channel. See below.
4.3
Setting the Camera Channel
The wireless camera has 4 selectable channels to avoid any interference from any other
wireless devices. Follow the steps below to set or change the frequency channel of the
camera. If you are adding another camera to an existing system, then ensure it's channel
is set to a different channel to the existing camera(s).
DIP Switch Tool
Note: It is
possible to link up to 4 wirefree cameras to the receiver; however you may need
to adjust the orientation of the antenna on the receiver depending on the reception of the
channel being viewed.
1. Pull open the rubber flap on the camera's power cable.
2. Locate the 2 dip switches under the rubber flap.
3. Set the camera channel as per the switch configuration
below using the DIP switch tool provided. Do not set
1 2
multiple cameras on the same channel or interference
may appear on screen.
(Optional)
Channel
Channel
Channel
1
2
1
2
1
2
9
Channel
3
4
1
2
1
2
Advertisement
Table of Contents
