S Registry; Overview S Registry - INSYS 56k Small INT 2.0 Manual Manual

INSYS Modem 56k Small INT 2.0
17

S Registry

S registries may be read and written using the ATS<n> command. (see also AT
Command Reference). Certain S registries may only be read; into others only a
particular range of values may be entered.
If the range of values is exceeded, the modem will report OK, although the value
was not accepted. We therefore recommend to immediately check modifications
by reading (ATS<n>?).
Note:
* These registries are stored in the user defaults with AT&W0 or AT&W1.
** The defaults can differ depending on the set country code.
17.1

Overview S Registry

Tabs Function
S0* Number of ringing tones until automatically going off-
hook
S1 Ringing tone counter
S2* Escape
S3 Return
S4 Linefeed character
S5 Backspace character
S6* Waiting period dial tone
S7* Waiting period carrier signal
S8* Dial tone delay
S9* Reaction time carrier signal
S10* Time period between lost carrier signal and hang up
S12* Transmission clock of the ESC characters
S13* Number of dialing attempts to send the message
S14* General settings
S15* Data Transmit Controller DTC
S17* Initial character for remote configuration
S21* Settings for V24
S22* Settings
S24* Time period until switching into sleep mode
S25 Time period for DTR signal
S26 Time period between RTS/CTS
S27* General settings
Units Range
Ringing 0-5
tones
Ringing 0-255
tones
ASCII 0-255
ASCII 0-127
ASCII 0-127
ASCII 0-255
s 3-7
s 0-100
s 1-7
0.1 s 1-255
0.1 s 14-254
0.02 s 0-255
1-12
1s 0-255
0-127
s 0-255
0.01 s 0-255
0.01 s 0-255
-
S Registry
Default
5
0
43
13
10
8
3
50
2
6
14
50
3
146
0
42
52
117
0
5
1
137
83