Manual Sending Of Messages; Switching On The Remote Configuration - INSYS 56k Small INT 2.0 Manual Manual

INSYS Modem 56k Small INT 2.0
12.10

Manual Sending of Messages

The group message or the individual pulse messages can be sent manually.
Configuration with HSComm
A manually triggered dispatch of the message with the software HSComm is
not possible.
Configuration with AT commands
To send the command, use the command:
12.11

Switching on the Remote Configuration

The INSYS Modem 56k Small INT 2.0 can be configured remotely. It has a remote configu-
ration mode. To configure the INSYS Modem 56k Small INT 2.0 remotely, a data connec-
tion to the modem to be configured must be established. This can be performed by call-
ing the INSYS Modem 56k Small INT 2.0 from any modem. After switching into the re-
mote configuration mode, AT commands can be sent to configure the INSYS Modem 56k
Small INT 2.0.
To switch into the remote configuration mode, a data connection must be established
between the modems. A particular connection type is not mandatory. We recommend
using only error-corrected connections for the remote configuration to avoid AT com-
mand transfer errors.
The remote configuration is active as default.
Configuration with HSComm
To enable the remote configuration, activate the checkbox "Automatic call ac-
ceptance" (Page 27, Figure 5: HSComm Modem - Tab Modem, Position 15).
Select an error correction type (Page 27, Figure 5: HSComm Modem - Tab Mo-
dem, Position 25). The remote access will not work in bi-directional mode.
You can define a password, which is queried after switching into the remote
configuration mode (Page 27, Figure 5: HSComm Modem - Tab Modem, Posi-
tion 24).
Use the function Selective call acceptance to restrict the dial-in at the INSYS
Modem 56k Small INT 2.0 to certain phone numbers. The selective call accep-
tance can only be configured via AT commands.
AT%A
Functions
39