INSYS 56k Small INT 2.0 Manual Manual page 38

Functions
To define the type of the message dispatch
(SMS to mobile phone, SMS to fixed network,
data connection, see Table 1: Type of message
transmission), use:
If you want to send the message to mobile
phones, e.g. in the D2 network, use:
The connection type depends on the type of transmission, the provider and
the end terminal. Please make sure to set the correct transmission type for the
message of the INSYS Modem 56k Small INT 2.0. If you set SMS to mobile
phone via D2, for example, you can only send SMS to mobile phones in the D2
network.
Some providers support the forwarding of a message to an e-mail address.
Please contact your provider for further information. The following table
shows various pre-settings of the INSYS Modem 56k Small INT 2.0 to send
messages to different end devices.
Data connection
SMS to Mobile
SMS to Mobile
SMS to Mobile
SMS to Mobile
Fax
SMS to mobile phone
or fixed network
Table 1: Type of message transmission
This setting must be saved.
To enter the message text, use the command:
After this command is entered, the modem
will respond and wait for the message text.
Enter the text and complete the entry with the
Enter key.
38
Transmission Protocol
PET
UCP
PET
UCP
AT*M<n>
AT*M4
Data Format
8N1 D1 or
E Network
7E1
7E1
8N1 D2 network
AT&W
AT*V
New alarm text:
INSYS Modem 56k Small INT 2.0
Example
AT*M0
AT*M1
AT*M2
AT*M3
AT*M4
AT*M5
AT*M6